Cybex 525AT Arc Trainer - Manual (Page 29)

29
Cybex Service Manual
Install Foot Plate Assembly
1. Slide foot plate onto the foot plate shafts.
1
4
3
5
2
6
Description
1 Rear foot plate shaft
2 Loctite
3 SHCS
4 Washer
5 Foot plate
6 Front foot plate shaft
2. Place a drop of loctite on each SHCS. Place another drop of loctite in each shaft (where the
SHCS will be tightened into).
3. Install both washers and both SHSC using a 3/16” Allen wrench.
Install Arm Handle Linkage
1. Install arm handle linkage to handle.
5
4
3
2
1
7
6
Description
1 Arm handle linkage
2 Spacer
3 Cap
4 Flat washer
5 SHCS
6 Hole (not shown)
7 Handle
2. Place a drop of loctite on SHCS. Place another drop of loctite into the threads of the shaft.
3. Install SHCS, flat washer, cap, and spacer securing the arm handle linkage using a 3/16” Allen
wrench. SHCS must be tightened to a minimum of 90 lbs-in.