Cybex 525AT Arc Trainer - Manual (Page 58)

58 59
Cybex Service Manual
Install front cover
Install the four short screws and one long screw securing the front cover and iPad clip to the console
assembly using a Phillips screwdriver.
2
1
3
4
Description
1 Console assembly
2 Short screws (4)
3 iPad clip
4 Long screw (1)
Test the unit for proper operation
1. Turn the main power switch to the on (I) position.
2. Begin striding the unit until the console lights up
3. Operate the unit at all levels to verify proper operation.
E3 View Monitor
Tools Required
• Phillips screwdriver
•
Utility knife
• ESD (Electrostatic Discharge) grounding strap.
Disconnect external power source
1. Turn the main power switch to the off (O) position.
2. Unplug the power cord from the power outlet.
WARNING: Shock and electrocution hazard
• Unplug unit and let sit 10 minutes before cleaning or performing maintenance
• Electrical charge can remain in unit after unplugging
• Keep water and liquids away from electrical parts
NOTICE: Component damage
Wear an ESD grounding strap during this procedure. Connect ESD grounding strap to
frame bolts or unpainted metal of frame. If ESD grounding strap is not available, touch
frame bolts or unpainted metal of frame before handling any electronics.