DFI RL830-C602/C604 - Manual (Page 10)

www.dfi.com
10
Chapter 2 Hardware Installation
Chapter 2
CPU
The system board is equipped with two surface mount LGA 2011 sockets. This socket is exclu-
sively designed for installing a LGA 2011 packaged Intel CPU.
Important:
1. Before you proceed, make sure (1) the LGA 2011 socket comes with a protective
cap, (2) the cap is not damaged and (3) the socket’s contact pins are not bent. If
the cap is missing or the cap and/or contact pins are damaged, contact your dealer
immediately.
2. Make sure to keep the protective cap. RMA requests will be accepted and pro-
cessed only if the LGA 2011 socket comes with the protective cap.
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
7. Seat the module vertically, pressing it down firmly until it is completely seated in the
socket.
6. Grasping the module by its edges, position the module above the socket with the “notch”
in the module aligned with the “key” on the socket. The keying mechanism ensures the
module can be plugged into the socket in only one way.
8. The ejector tabs at the ends of the socket will automatically snap into the locked position
to hold the module in place.
Protective
cap