DFI RL830-C602/C604 - Manual (Page 41)

www.dfi .com
41
Chapter 3 BIOS Setup
Chapter 3
DIMM Information
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1229. Copyright (C) 2012 American Megatrends, Inc.
CPU Socket 0 DIMM Information
Node 0 Ch 0 Dimm 0
Node 0 Ch 0 Dimm 1
Node 0 Ch 1 Dimm 0
Node 0 Ch 1 Dimm 1
Node 0 Ch 2 Dimm 0
Node 0 Ch 2 Dimm 1
Node 0 Ch 3 Dimm 0
Node 0 Ch 3 Dimm 1
CPU Socket 1 DIMM Information
Node 1 Ch 0 Dimm 0
Node 1 Ch 0 Dimm 1
Node 1 Ch 1 Dimm 0
Node 1 Ch 1 Dimm 1
Node 1 Ch 2 Dimm 0
Node 1 Ch 2 Dimm 1
Node 1 Ch 3 Dimm 0
Node 1 Ch 3 Dimm 1
Not Present
Not Present
Not Present
Not Present
Not Present
Not Present
Present 1024MB Independent
Not Present
Not Present
Not Present
Not Present
Not Present
Not Present
Not Present
Not Present
Not Present
Chipset


Enter:
+/-:
F1:
F2:
F3:
F4:
ESC:
Select Screen
Select Item
Select
Change Opt.
General Help
Previous Values
Optimized Defaults
Save and Reset
Exit
South Bridge
This section is used to configure the parameters of South Bridge.
Specify what state to go to
when power is re-applied
after a power failure (G3
State).
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1229. Copyright (C) 2012 American Megatrends, Inc.
PCH Information
Name
Stepping
SB Chipset Confi guration
After G3
Disable SCU devices
Onboard SAS Oprom/Driver
Onboard SATA RAID Oprom/Driver
High Precision Event Timer Confi guration
High Precision Timer
 USB Confi guration
Patsburg
06 (C1 Stepping)
[Power On]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
Chipset
After G3
Specifies what state to go to when the power is reapplied after a power failure (3
State).
Power Off
When power returns after an AC power failure, the system’s power is off. You must
press the Power button to power-on the system.
Power On
When power returns after an AC power failure, the system will automatically power-on.
Last State
When power returns after an AC power failure, the system will return to the state
where you left off before power failure occurs. If the system’s power is off when AC
power failure occurs, it will remain off when power returns. If the system’s power is on
when AC power failure occurs, the system will power-on when power returns.
Disable SCU devices
Enables or disables the patsburg SCU devices. SMBus 0/1/2 will be disabled while SCU
devices are disabled.
Onboard SAS Oprom/Driver
Controls whether to enable the onboard SAS option ROM or EFI driver.


Enter:
+/-:
F1:
F2:
F3:
F4:
ESC:
Select Screen
Select Item
Select
Change Opt.
General Help
Previous Values
Optimized Defaults
Save and Reset
Exit