Autolog2 troubleshooting, Rpm sensor diagnostics, Autolog – Digi-Star GT460 User Manual
Page 46: Troubleshooting
AutoLog2 Troubleshooting
AUTOLOG
2
TROUBLESHOOTING
If your system has been operating, execute the following sensor
diagnostics to verify the RPM sensor is sending pulses to the indicator.
RPM Sensor Diagnostics
1. Enter 508 press
2. Press to select
on
and
press enter.
3. Press until
DIAG
is
displayed.
4. Press
5. Display will show value from
RPM sensor.
Note:
The RPM value should be close to the actual RPMs of the shaft.
For best results adjust the distance between the sensor and the target to
between 0.1" and 0.2" (2mm to 5mm). This is equal to the thickness of
one to two quarters.
Sensor has yellow LED indicator on rear to indicate target in range of the
sensor.
DIAG
is to be used as a diagnostic tool. Repeat steps 1 and 2 to select
off
once troubleshooting is complete.
SENSOR AND TARGET INSTALLATION
1
4
2
3
1
5
46
GT460 AutoLog
2
Operators Manual
D3804