Flowserve StarPac 3 User Manual
Page 42
Advertising
StarPac Intelligent Control System FCD VLENIM0066-05 04/14
42
®
The following tools are required:
• Phillips screwdriver
WARNING: Observe precautions for handling electrostatically sensitive devices.
1. Make sure the valve is bypassed or in a safe condition.
2. Disconnect the power and air supply to the unit.
3. Remove the main cover.
4. Remove the keypad by removing the two retaining screws. Unplug the keypad ribbon cable from the main
PCB board and remove the keypad.
Figure 21: Main PCB Assembly
STOP!
Keypad
Main PCB
Assembly
Regulator
Advertising