Flowserve StarPac 3 - Manual (Page 8)

StarPac Intelligent Control System FCD VLENIM0066-05 04/14
8
®
The sealing tape and desiccant should be removed when instrument air is permanently applied to the positioner
All of the edges around the vent assembly should be sealed similar to picture below.
Desiccant packet
Removable sealing tape
2 Unpacking
1. While unpacking the StarPac 3 Intelligent Control System, check the packing list against the materials recei-
ved. Lists describing the system and accessories are included in each shipping container.
2. When lifting the control system from the shipping container, use straps through the yoke legs, or the lifting
lugs attached to the yoke bolting. Take care to position lifting straps to avoid damage to the tubing and moun-
ted accessories.
WARNING: When lifting a control system, be aware that the center of gravity may be above the lifting point.
Therefore, support must be given to prevent the valve from rotating. Failure to do so can cause serious injury to
personnel and damage to the valve and nearby equipment.
3. Contact your shipper immediately if there is shipping damage.
4. Should any problems arise, call your Flowserve representative.
3 Installation
DANGER: Before installation check the order number, serial number, and/or the tag number to ensure that the
valve and actuator being installed are correct for the intended application.
CAUTION: Do not insulate extensions that are provided for hot or cold services. Do not insulate the StarPac 3
electronics housing or remote-mounted pressure or temperature sensors; otherwise excessive heat may build up
and affect operation.
CAUTION: If the StarPac 3 is being installed in an insulated process line, do not place more than four inches of
insulation around the pressure or temperature sensors.
STOP!