Flowserve StarPac 3 User Manual
Page 51
51
StarPac Intelligent Control System FCD VLENIM0066-05 04/14
flowserve.com
®
Table XVII: Pressure Sensor Hardware Kits
Item No. Description
Quantity
Kit 5 - Pressure Sensor Connection Kit Configuration, Part No.
134555.999.000
3
Swagelok nut
2
4
Swagelok ferrules
2
5
Sensor nut
2
6
Environmental O-ring, Viton®
2
7
Division II sensor fitting
2
NOTE: Kit will service two pressure sensors. For class I,
Division II, Group A, B, C, & D. See Table XIIX for Tubing.
Item No. Description
Quantity
Kit 6 - Remote Mount Pressure Sensor Hardware Kit, Part
No. 134557.999.000
3
Swagelok nut
4
4
Swagelok ferrules
4
15
Temperature extended fitting
2
19
Adapter fitting
2
NOTE: Kit will service two remote-mount pressure sensors. See
Table XIIX for tubing. (Wet-leg tubing wall thickness must be
0.065-inch).
Item No. Description
Quantity
Kit 7 - Remote Mount Pressure Sensor Hardware Kit with
Purge and Isolation Valves, Part No. 134558.999.000
3
Swagelok nut
4
4
Swagelok ferrules
4
15
Temperature extended fitting
2
16
Purge valve
2
17
Isolation valve
2
19
Adapter fitting
2
NOTE: Kit will service two remote-mount pressure sensors. See
Table XIIX for tubing. (Wet-leg tubing wall thickness must be
0.065-inch).
Item No. Description
Quantity
Kit 8- Pressure Sensor Electrical Cable Replacement Kit,
Part No. 134563.999.000
1
Electrical connector cable
2
22
Four-pin connector
2
23
Wire crimp terminal
16
NOTE: Kit will service two pressure sensors.
Description
Quantity
Kit 9 - Pressure Sensor Electrical Extension Cable, Part
No. 127645.999.000
Electrical connector extension cable
1
Description
Quantity
Kit 10 - Pressure Sensor Calibration Kit, Part No.
134564.999.000
Pressure sensor calibration fixture
1
Electrical connector extension cable
2
O-ring seal, Viton
2
Description
Quantity
Kit 11 - DP Cell Manifold Replacement, 3-Valve,
Part No. 134564.999.000
Valve Manifold
1