8 clock module command line syntax, 3xe d – GAI-Tronics VoIP Telephone Software Configuration Guide User Manual
Page 78
GAI-TRONICS
VoIP Telephone Configuration Guide
Page 78 of 88
Action
Verb
Parameters
Comment
1 2 3
SHOW ALL
This command lists the current settings of the memory dial
locations 1 – 20 and also lists the order of use of lists 1-10 and
the emergency list It also displays the values for the other
variables that can be configured in this module.
9.8
CLOCK Module Command Line Syntax
Action
Verb
Parameters
Comment
1 2 3
SET
SNTP
xxx.xxx.xxx.xxx
or
FQDN
Sets the IP address of the SNTP server to be
xxx.xxx.xxx.xxx or resolves the FQDN using DNS to
locate the host from which the phone obtains time
data.
TIMEZONE XXXX
This command sets the current time zone for local
time where XXXX is an abbreviation selected from
the time zone abbreviations in section 7.
FORMAT
[US | UK]
Sets the format of the date to be either US style
MM/DD or UK style DD/MM. Default value is UK.
DST
ADJUST ON/OFF
This command determines if the unit’s clock will
automatically adjust to daylight saving time. The
default value is OFF
OFFSET +/-HH:MM
This command sets the value of the offset from the
current clock time applied when the DST period
starts. Valid values for HH are 00 – 12 and for MM
they are 00 – 59. The default value is +01:00 ( 1
hour)
STARTDAY
[0 – 31]
If DST is active, these commands define when it
starts and ends. Refer to Clock Settings web page
section for detailed explanation. The example file in
Section 8 lists the commands to set DST to be active
between 2am on the last Sunday in March until 2am
on the last Sunday in October.
STARTDOW [1-7]
STARTMONTH [1-12]
STARTWOM
[1-6 | 8]
ENDDAY [1-31]
ENDDOW [1-7]
ENDMONTH [1-12]
ENDWOM
[1-6 | 8]
STARTTIME HH:MM
ENDTIME HH:MM
3XE
D