9 audio module command line syntax, 10 tones module command line, 3xe d – GAI-Tronics VoIP Telephone Software Configuration Guide User Manual
Page 79
GAI-TRONICS
VoIP Telephone Configuration Guide
Page 79 of 88
9.9
AUDIO Module Command Line Syntax
Action
Verb
Parameters
Comment
1 2
SET
CODEC A,B,C,D,E,F
This command sets the order of preference that will be
used in the SDP by the phone, where A B C D E and F
can have the values 1 -6 that corresponds to the CODECS
listed in the Audio web page section above.
Note VAD must be set to ON when using G.729 Codec.
SAMPLE
G711
10
Set the sample period in ms. See 5.13
20
G722
10
20
G729
10
20
FRAMES
G7231
| G722
|G729
|G711
X
This command sets the number of audio sample periods or
“frames” per IP packet . See 5.13
VAD
[ON | OFF ]
This command enables or disables the use of Voice
Activity Detection. This command is only valid for G723
and G729 Codec settings.
Note VAD must be set to ON when using G.729 Codec.
The default value is ON.
DTMF
[ INBAND |
RFC2833 ]
This command sets the transmission of DTMF digits to be
either in band or out of band. The default setting is
OUTBAND, DTMF is transmitted using RFC 2833
DTMFPT [96-127]
Sets the payload type parameter in the RTP packets when
sending DTMF tones 'out-of-band' according to RFC2833.
The default value is 96, but should be changed to 101 for
compatibility when using Cisco CallManager™.
DTMFPLAYBACK [ON|OFF]
sets whether DTMF tones are heard in the earpiece when
digit buttons 0-9, * or # are pressed. Default value OFF.
HANDSETGAIN
HANDSETVOLUME
LINEGAIN
LINEVOLUME
RINGERVOLUME
HANDSFREEGAIN
HANDSFREEVOLUME
XX
These commands specify the various gains and volumes.
Refer to Audio settings web page section for definitions
and acceptable value ranges.
SET
SIDETONE
ON/OFF
Enables or disables sidetone. OFF by default.
SIDETONELEVEL
[ 0-255 ]
If sidetone is set to ON, this parameter sets its level.
Range is 0-255, default value 127.
JITTERMIN
30 -> 120
Minimum size of dynamic jitter buffer.
JITTERMAX
30 -> 120
Maximum size of dynamic jitter buffer.
SHOW
ALL
Lists all the configuration settings for the Audio module
9.10 TONES Module Command Line
Action
Verb
Parameters
Comment
1 2 3
SET
TONE[1-10]
FREQ [1-13]
This command sets the frequency (or frequency pair)
[1-10] referenced in parameter 3 for the Tone
referenced in parameter 1. See Tone Settings web
page section (5.15) for detailed explanation.
[ON1 | ON2 | ON3 |
OFF1 | OFF2 | OFF3]
X
This command sets up the timing for the cadence
period referenced in parameter 2 with the value X
where X is an integer value between 0 and 600 that is
equivalent to the period’s time in 25ms increments.
See Tone Settings web page section (5.15) for
detailed explanation.
SHOW
ALL
This command displays the current settings of all the
tone parameters.
3XE
D