18 multicast module command line syntax, 3xe d – GAI-Tronics VoIP Telephone Software Configuration Guide User Manual
Page 85
GAI-TRONICS
VoIP Telephone Configuration Guide
Page 85 of 88
9.18 Multicast Module Command Line Syntax
Action
Verb
Parameters
Comment
1 2
3
SET
TIMEOUT [1-120]
sets an enforced delay (in seconds) between one
Multicast session ending and another beginning.
Range 1-120. Default 120
SPEAKERV
OLUME
1-10
sets the speaker volume during a multicast. Volume
will revert to the setting on the AUDIO page when the
multicast session has ended. Range is 1 to 10, default
value 3.
OVERRIDE
0-8
Priority level. See section 5.18.
ADDRESS
[1-8]
xxx.xxx.xxx.xxx:pppp
Multicast address, must include multicast port.
FILTER xxx.xxx.xxx.xxx:xxx.xxx.xxx.xxx
Sets a range of acceptable multicast source IP
addresses. The phone will only accept a multicast if
the source is within this IP address range. The format
is 2 IP addresses separated by a colon. The default
is 0.0.0.0:255.255.255.255
PRIORITY
[0-8]
Priority level. See section 5.18.
OUTPUT1
[ENABLED | DISABLED]
sets if OUTPUT1 is ENABLED or DISABLED during
this multicast
OUTPUT2
sets if OUTPUT2 is ENABLED or DISABLED during
this multicast
TONE
sets if tone 10 (TONES page) is ENABLED or
DISABLED during this multicast.
SHOW ALL
3XE
D