Installation and operating instructions, Operation and test (cont.), Fig. 17 setting the alarm time delay – Louroe Electronics DG-12II User Manual
Page 25
PAGE 22 of 28
OPERATION AND TEST (cont.):
13).
Set the alarm time delay as follow:
a.
Connect the second test cable with a 3.5mm stereo plug on one end and a
3-pin din plug on the other (supplied) between the Alarm Delay Output
jack[23] and the Alarm Delay Input Jack[8]. See Fig. 17 above. Plug the 3.5
mm plug to the Alarm Delay Output Jack[23] of zone 1 module (first from the
left).
b.
Push the Tester Reset Pushbutton[11]. The time shown on the Alarm Delay
Indicator [18] should reset to “0.0” (zero). The time is measured in seconds.
c.
Starting with zone 1 module, push and released immediately the Tester Trigger
Pushbutton[10]. The unit will go into alarm. The Alarm Indicator LED[2] will
turn from green to red.
d.
Check the reading on the Alarm Delay Indicator[18]. It should indicate the
factory setting for the length of time the alarm should stay on before the unit
foes into alarm (0.1's).
e.
If the required time delay for that zone needs to be increased, flip the Time
Delay Switch[5] upwards.
f.
Push the Tester Reset Pushbutton[11] to reset the time delay to zero as
shown by the Alarm Delay Indicator[18].
g.
Push and release quickly the Alarm Delay Setting Pushbutton[19] the
number of times necessary to attain the correct time delay.
h.
Push the Tester Trigger Pushbutton[10]. Zone 1 will again go into alarm.
i.
Check the reading of the Alarm Delay Indicator[18]. The new time is now
indicated. If the time is still below the desired time, repeat steps 13f thru 13i.
j.
If the required time delay needs to be decreased, or after performing step 13g,
the time goes over, flip the Time Delay Switch[5] downwards.
k.
Push the Tester Reset Pushbutton[11] to reset the time to zero.
l.
Quickly push and release the Alarm Delay Setting Pushbutton[19] a number
of times necessary to attain the desired time.
m.
Push the Tester Trigger Pushbuttton[10] Zone 1 will again go into alarm.
n.
Check the reading of the Alarm Delay Indicator [18]. The new time is now
indicated. If the times is still below the desired time, repeat steps 10k thru 10m.
Fig. 17 Setting the alarm time delay
7
19
4
23
8
5
INCREASE
DECREASE
INCREASE
DECREASE
INCREASE
DECREASE
DG_12II_6/11
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406
TEL (818) 994-6498
FAX
994-6458
website: www.louroe.com e-mail: [email protected]
(818)
®
INSTALLATION AND OPERATING INSTRUCTIONS