MBM Corporation 49 - Manual (Page 14)

T10114 Jan 2001
Sheet Feeder Model 49 Operator Manual
3.2 Adjusting the Separation
separator pads
separator pads
adjustment knob
feed belt rollers
The drawing to the left shows schematically how the
separation works and the name of the different parts.
Tightening the separator pads adjustment knob, moves the
rollers and the separator pads closer to the feed belt. Adjust
the separation as follows.
Documents over 3 mm thickness.
Place the document between the rollers and the feed belts
as shown. Tighten the separator pads adjustment knob until
the feed belts moves when the booklet is pulled back and
forth.
Documents up to 3 mm thickness.
Place the document between the separator pads and the
feed belt as shown. Tighten the separator pads adjustment
knob so the next booklet stays in front of the separator pad
when the first one is fed.
Single sheets.
Place two sheets between the separator pads and the feed
belt as shown. Tighten the separator pads adjustment knob.
Then release until the top sheet can be pulled out.
Check adjustment in the proof menu. Press the up arrow
button to feed step by step. To feed an entire set, press the
OK button.
3-4