MBM Corporation STITCHFOLD Trimmer - Manual (Page 12)

12
Trimmer
JAM CLEARING & RESTART:
1. Turn off power to the trimmer.
2. Remove work jam. DO NOT REACH UN-
DER THE KNIFE! SEVERE LACERA-
TIONS OR DISMEMBERMENT COULD
RESULT.
3. Close all safety covers.
4. Depress "POWER ON" switch to turn on
power.
3. Depress "START/RESET" switch to energize
control cicuit. The electric motor and con-
veyor clutches will energize so trimming may
resume.
JAM OUTPUT:
When a jam occurs a normally closed relay in the
control panel closes. This relay is connected to
a .141" diameter female phone jack outlet (fig 18)
located on the power cord bracket. Any device
plugged into the phone jack will receive a closed
circuit signal, which that device can use to shut
down any upstream machines feeding work to the
trimmer.
DANGER
NEVER REACH UNDER THE
KNIFE! SEVERE LACERATIONS
OR DISMEMBERMENT COULD
RESULT!
BELT DRIVE:
The purpose of the "BELT DRIVE" rotary switch
(fig 19) is to make sure the work will square up
against the back stop to provide a good square cut
booklet.
The "1" setting means that the internal conveyor
belts will shut off quickly after the work is sensed
allowing time for the work to square up against
the back stop.
If the work does not square up fully against the
back stop before being trimmed, rotate the switch
to postition "2". This position allows the internal
conveyor belts to run for an additional short pe-
riod of time (after the work is sensed) so that the
work will square up before being trimmed.
Positions "3" through "6" allow for progressively
longer conveyor belt running time for unusual work,
such as work that may slip on the conveyor belts,
to square up against the back stop.
(Fig 19)
(Fig 18)
(SK891C Scene 1)