MBM Corporation STITCHFOLD Trimmer - Manual (Page 9)

9
TRIMMER HEIGHT:
The height of the trimmer can be adjusted up or
down slightly by use of the threaded adjustable
casters and locking nuts on the bottom of the trim-
mer or trimmer stand (fig 13).
SETUP
TRIM LENGTH:
To set the back stop assembly for the desired trim
length, loosen the two thumb screws (fig 14) and
slide the back stop assembly forward or back-
DISCHARGE TABLE ROLLERS:
Set the discharge table rollers forward for small
booklets or backward for large booklets. To adjust
the rollers, loosen thumb screws (fig 15), move
roller brackets to desired location, then retighten
thumb screws.
(Fig 13)
(Fig 14)
(Fig 15)
ward to the desired location. There is a pointer
on the side of the back stop assembly that points
to a trim length scale installed on the inside wall
of the trimmer. Once located in the desired
position tighten the two thumb screws.