MBM Corporation 102 - Manual (Page 13)

T10087 Febrary 1999
Stapler Folder Model 102 Operator Manual 3-6
3.3 Feeding and adjusting a test set, continues
7 Close the top cover.
8 Feed one set of the chosen paper size into the model 102 (The ma-
chine will repeatedly make a jog cycle).
9 Open the top cover.
10 Press and hold the staple stop adjustment button until the trail edge of
the set reaches the paper size mark on the staple fold/line scale. If the
required paper size mark not is visible (the set is to close to the
infeed), press the staple stop adjustment button until the set passes
the required paper size mark (towards the outfeed). Ensure that the
set is aligned against the staple stop and press the staple stop adjust-
ment button until the trail edge of the set reaches the paper size mark
on the staple fold/line scale.
11 Press the side jogger button until the side joggers jogg the set firmly
without making a buckle in the set.
12 Press and hold the back jogger button until the back jogger is approxi-
mately 1 mm from the set.
13 To store your settings:
• press the format adjustment access button (the +/- button) to keep your
settings temporarily. Your settings are not stored but will remain until a
paper size format button is pressed even if the power is switched off.
• press the memory button to store your settings on the actual paper
size button, earlier selected according to section 3.2.
• or, select any other paper size program button and then press the
memory button.
NOTE1: Side stapling or corner stapling of A3 paper format (or similar
sizes) is not possible.
NOTE2: You can store 4+4 different settings. Four in the staple/fold or
fold only finishing mode, and four in the corner or side stapling
finishing mode.
14 Close the top cover. The paper set moves to the belt stacker.
15 In booklet finishing mode: If the cover is torn from the body sheets
increase the gap between the fold rolls by adjusting the fold adjust
levers from the factory setting 1 to a higher number.
moving the
staple stop
towards the
infeed
moving the
staple stop
towards the
outfeed