MBM Corporation 102 - Manual (Page 22)

T10087 February 1999
Stapler Folder Model 102 Operator Manual
4.2 Removal/replacement of the stapler head, continues
4-5
4 Before inserting the stapler head, centre the movable carrier over the
area that will receive the stapler head. Ensure that the staple driver
post is in its uppermost position.
5 Place the stapler head back into the Model 102. The front tab of the
stapler assembly must be placed under the nylon tension spring and
the driver post arm placed into the carrier.
7 Lock the pin by rotating it towards the in-feed side. Check that the
stapler head is correctly mounted by pushing the stapler head towards
the infeed area.
8 Insert the red wire into its outlet.
6 Press on the lower front edge of the stapler head to align the hole in
the stapler bracket with the hole in the stapler head. Insert the lock
spring so that it engages the stapler head and the metal sides of the
stapler assembly.
6 8
4
5
driver post arm
CAUTION: If the driver post arm is not correctly positioned into the
carrier (4) it will cause permanent damage to the stapler
head as well as the carrier. Subsequently, also future cor-
rectly mounted stapler heads will be damaged.