Microcom 326M User Guide - Manual (Page 20)

Getting Started Chapter 3
8
326M User’s Guide
3.2.1 Printer Power
Microcom Corporation offers a “desk type” universal power adapter as an option for the
326M and 426M printers. Any power adapter that conforms to the necessary specifications,
listed below, may be used. The printer requires a universal +24VDC 100 Watt power supply
that operates in the 90-264 VAC; 50-60 Hertz range; 4.2 Amps at a minimum. The power
supply
should operate in an “output foldback mode” during an overload situation rather than
a shutdown and restart attempt ( sometimes referred to as “Hiccup” mode). Contact your
Microcom Corporation representative for any questions regarding power adapter
requirements and/or specifications.
AC Input: 90-264 VAC, 50/60HZ
DC Output: +24Vdc, 4.2 Amps
Power Rating: 100 Watts
Overload Mode: Output Foldback Mode
Printer Power Connector: 4 Pin Power mini-DIN Connector
Table 4 Minimum Power Supply Specifications
Note: Verify that the power supply jack is plugged into the printer before
plugging the power cord into an electrical outlet
Figure 4 Connecting the Power Adapter (426M)
4-Pin Power Mini
Din Connector