Microcom 326M User Guide - Manual (Page 37)

Chapter 4 Printer Modes
326M User’s Guide
25
4.2.3.24 >UNSUPPORTED FILE TYPE< (D5)
This enquiry response indicates that the printer does not recognize the type of the received
file while in text and verbose modes. If the printer is configured for byte responses, the
code ASCII 0xD5 will be issued from the printer in response to an enquiry command.
4.2.3.25
>FILE NOT FOUND< (D6)
The “>FILE NOT FOUND<” response typically indicates that the printer is being instructed to
recall and process a file that does not exist in the printer’s memory while in text and verbose
response sets. If the printer is configured for byte responses, the code ASCII 0xD6 will be
issued from the printer in response to an enquiry command.
4.2.3.26
>INADEQUATE ACCESS MODE< (D7)
This enquiry response is typically issued when the user is attempting to issue a persistent
command that is not allowed by the current access mode level or is attempting to enter an
access mode that has a higher security level. If the printer is configured for byte responses,
the code ASCII 0xD7 will be issued from the printer in response to an enquiry command.
4.2.3.27
>FILE IS READ ONLY< (D9)
This enquiry response typically indicates that a save or delete command is being issued to
the printer and that the file is a protected file stored in the printer. If the printer is configured
for byte responses, the code ASCII 0xD9 will be issued from the printer in response to an
enquiry command.
4.2.3.28
>INADEQUATE FLASH SPACE< (DA)
This enquiry response indicates that the available flash memory is less than the total size of
a file being saved to flash memory. If the printer is configured for byte responses, the code
ASCII 0xDA will be issued from the printer in response to an enquiry command.
4.2.3.29
>I/O FAILURE< (DB)
This enquiry response indicates that the printer has a failure with either the I/O hardware or
with the I/O firmware. If the printer is configured for byte responses, the code ASCII 0xDB
will be issued from the printer in response to an enquiry command.
4.2.3.30
>FONT/GRAPHIC NOT FOUND< (DC)
This enquiry response typically indicates that a font being specified a script file does not
exist in flash memory. If the printer is configured for byte responses, the code ASCII 0xDC
will be issued from the printer in response to an enquiry command.
4.2.3.31
>SWITCH 0 ACTUATED< (E1)
This enquiry response typically indicates that switch 0 is actuated while in text or verbose
response sets. If the printer is configured for byte responses, the code ASCII 0xE1 is
issued from the printer in response to an enquiry command.