Microcom 326M User Guide - Manual (Page 35)

Chapter 4 Printer Modes
326M User’s Guide
23
4.2.3.10 >LABEL/TAG PRESENT< (86)
This response indicates that media is blocking the Label Present Sensor (LPS) and
protruding out the front of the printer. If the printer is configured for byte responses, the
code ASCII 0x86 will be issued from the printer in response to an enquiry command.
4.2.3.11
>STOCK ADVANCED< (87)
The “>STOCK ADVANCED<” response indicates that the media has been advanced after
printing when a Dispense Mode (^D597) command) is being used while in text and verbose
response sets. If the printer is configured for byte responses, the code ASCII 0x87 will be
issued from the printer in response to an enquiry command.
4.2.3.12
>FLASH DEFRAGMENTING< (8A)
The “>FLASH DEFRAGMENTING<” response indicates that the printer is optimizing the
flash memory and is currently not available while in text and verbose response sets. If the
printer is configured for byte responses, the code ASCII 0x8A will be issued from the printer
in response to an enquiry command.
4.2.3.13
>STOCK NOT LOADED< (8F)
The “>STOCK NOT LOADED<” response indicates that media is not being detected in the
printer on power up while in text and verbose response sets. If the printer is configured for
byte responses, the code ASCII 0x8F is issued from the printer in response to an enquiry
command. This message persists until media is detected at the registration mark sensors
but does not prevent commands from being processed.
4.2.3.14
>RETRACTION DELAY< (90)
The “>RETRACTION DELAY<” response indicates that the printer has been configured
with a delay before retracting, refer to the ^D641) command, while in text and verbose
response sets. If the printer is configured for byte responses, the code ASCII 0x90 will be
issued from the printer in response to an enquiry command.
4.2.3.15
>PRINT DELAY< (91)
The “>PRINT DELAY<” response indicates that the printer has been configured with a delay
between labels, refer to the ^D640) command, while in text and verbose response sets. If
the printer is configured for byte responses, the code ASCII 0x91 will be issued from the
printer in response to an enquiry command.
4.2.3.16
>FLASH MEMORY LOW< (B0)
The “>FLASH MEMORY LOW<” response indicates that the user storage area of the flash
memory is 95% full while in text and verbose response sets. This message will continue to
be received until files are removed from flash memory or until the printer performs garbage
collecting and defragmenting. If the printer is configured for byte responses, the code ASCII
0xB0 will be issued from the printer in response to an enquiry command.