MicroLinks PRO10 - user guide User Manual
Page 16
14
The transmission line is applied in TV Out mode. Link smaller
joint to the microscope host, and the larger one (yellow) to TV.
After linkage, switch to the main menu or Camera mode, the
system will output the image to the TV automatically. Watch
the screen of the TV to operate or observe. The mode is
showed in the following image.
(3) Install USB Power Supply Device: provide power supply for
the machine by USB transmission line and USB power supply
device. Smaller joint is applied to connect microscope host,
and the larger one is applied to connect USB power supply
device (or USB connection port connecting to computer can
also provide power supply). The installation is as follows.
(4) Install SD Card: remove battery and the cover, and then push
away upper cover of memory card holder. Place SD Card
correctly and push the cover back (locking). Place the battery
and close the cover. Please turn off the power supply before
handling SD Card. Do not conduct hard handling. Please refer
to the following image.
(5) Install Battery: remove the battery cover and input the battery
by placing the written face up and complying with positive
and negative poles correctly. Close battery cover finally.
Please refer to the following image.