Microsens MS453522M - Manual (Page 23)

MICROSENS 8 Port Gigabit Ethernet Switch User’s Manual
18
• Set IP Address, Subnet Mask and Default Gateway IP Address
Please refer to Fig. 2-7 CLI Management for details about the ex-factory setting. They are
default setting of IP address. You can first either configure your PC IP address or change IP
address of the switch, next to change the IP address of default gateway and subnet mask.
For example, your network address is 10.1.1.0, and subnet mask is 255.255.255.0. You can
change the switch’s default IP address 192.168.1.1 to 10.1.1.1 and set the subnet mask to be
255.255.255.0. Then, choose your default gateway, may be it is 10.1.1.254.
Default Value 8 Port Gigabit Ethernet Your Network
IP Address 192.168.1.1 10.1.1.1
Subnet 255.255.255.0 255.255.255.0
Default 192.168.1.254 10.1.1.254
Table 2-3
After completing these settings in the switch, it will reboot to have the configuration
taken effect. After this step, you can operate the management through the network, no matter
it is from a web browser or Network Management System (NMS).
Fig. 2-8 the Login Screen for CLI