MMD Equipment 185S-6C1 - Manual (Page 18)

3. Installation
3-2
PC002
A070192-1
3.2 Towing the Unit
Before towing the unit, check the following points and be sure to repair failures, if any:
Air-pressure in the tires.
Loose wheel bolts or nuts.
Abnormal wear or damage to the tires.
Damage of drawbar.
Be sure to use a vehicle with enough capacity to tow the unit in operating weight.
Do not tow the unit without unfastening tool, equipment, and hoses.
Keep hands and fingers clear during hook-up or unhooking drawbar.
If you do not follow the above instructions, it could cause serious injury or big damage.
3.3 Installation
Exhaust gas from the engine is poisonous, and could cause
death when inhaled.
Avoid using the machine in an insufficiently ventilated
building or tunnel.
Do not position the exhaust gas outlet in direction of a person
or a house.
The machine has to be parked horizontally on a
level place.
In case the machine has to be parked on a slope,
place it across grade so that the machine does
not tend to roll downhill.
Following grades on a slope for the machine are
recom- mended within 15 ° degrees.
In case of trailer type, be sure to put one set of
chocks “1” to the wheels.
The machine should be operated in following conditions:
Ambient temperature ･･･････ 5°F to 104°F( -15℃～＋40℃)
Humidity ･････････････････ Less than 90%
Altitude ･･････････････････ Lower than 1,500 m above sea level
Install the machine in a place with good ventilation, lower temperature and with surroundings as
dry as possible.
If more than two machines are placed parallel in operation, keep enough distance so that exhaust
air from one machine does not effect the other one.
Also, a machine has to be installed in the environment where fresh air is always available.
Keep enough space around the unit for inspection and maintenance access.
Installation
1