MMD Equipment 185S-6C1 - Manual (Page 29)

4. Operation
4-11
D003
PK0028
4.4 Operation
Do not operate the machine with service valves and relief valve
open unless air hoses and/or pipes are connected.
High-pressurized air blows out and its air pressure could cause
injury to the people nearby.
When the machine has to be unavoidably temporarily operated
with its port open, be sure to mount a silencer to reduce noise and
wear protective materials such as earplugs to prevent damage to
hearing.
Since this equipment is provided with a quick glow system (quick preheating device), you do not have
to turn the starter switch counterclockwise from STOP position.
Turn the starter switch to the “RUN” position, and the preheating will be completed in several seconds
and the preheating lamp will go out. Then, turn the Starter Switch to the Start position to start up the en-
gine.
When the engine is already warm, the preheating operation is automatically omitted. Even though the
preheating lamp lights up momentarily, ignore the lamp status, and start up the engine.
WARNING – Because of the quick glow system, never use ether to start engine.
Keep the door closed and locked while running the unit.
When the door has to be opened, be careful not to touch portions
that are rotating or very hot.
Careless touch may cause serious injury.
Pull the handle forward to open the door.
Be sure to close the door tightly so that its latch is firmly caught.
Operation with compressed air supply port opened is prohibited
Quick Glow System