Periodic inspection/maintenance – MMD Equipment 185S-6C1 User Manual

Page 45

Advertising
background image

5. Periodic Inspection/Maintenance

5-8

W010


5.5.5 Change compressor oil

[At 300 hours for the first change and at every 500 hours thereafter]

When you refill the separator receiver tank with compressor oil,
stop the engine, and make sure that the pressure gauge indicates
0MPa and there is no residual pressure in it, and then gradually
loosen the oil filler cap for refilling oil.

Note residual pressure in the receiver tank could force both
extremely hot compressed air and oil to jet out and you may be
scalded or seriously injured.

Even continuous oil replenishment cannot improve its deteriorated
condition. Be sure to change the oil completely at every scheduled interval.

Do not mix it with other brand oil, or it will cause poor performance and shorten the life of the compres-
sor oil. (But fresh compressor oil could accept a mixture of small amount of different brands.)

Running the unit with old and deteriorated compressor oil will cause damage to bearings, or serious ac-
cident like ignition in a separator receiver tank. Be sure to change the oil completely at every scheduled
interval.

Follow the designated regulations to dispose of compressor oil.

Procedure>

Remove the oil filler cap“1”of separator receiver
tank.

Open drain valve“2”to discharge waste oil from the
tank.

Completely discharge all the oil left separator re-
ceiver tank, pipes and oil cooler. If wasted oil is left
in the unit, this residual oil will greatly shorten the
life of the newly replenished oil.

Be sure to close drain valve“2”after the used oil is
completely discharged.

Fill the designated quantity of new oil through the
oil filler port.

After oiling, tighten the cap“1”in its place while
paying attention not to let dust get in the tank.

Start the engine for a short while, then replenish the
oil to fill shortage. Repeat this procedure for 1 to 2
times to check if the oil level has reached its appro-
priate point. Be careful not to overfill the oil.

1

2

Refilling of compressor oil

A070230

Advertising