MMD Equipment 185S-6C2 - Manual (Page 19)

3. Installation
3-3
3.3 Installation

Exhaust gas from the engine is poisonous, and could cause
death when inhaled.
Avoid using the machine in an insufficiently ventilated
building or tunnel.

Do not position the exhaust gas outlet in direction of a
person or a house.
 The machine should be operated in following conditions:
 Ambient temperature
･･･････
5°F to 104°F( -15℃～＋40℃)
 Humidity ･････････････････ Less than 90%
 Altitude ･･････････････････ Lower than 4,921ft above sea level
 Install the machine in a place with good ventilation, lower temperature and with surroundings as
dry as possible.
 If more than two machines are placed parallel in operation, keep enough distance so that exhaust
air from one machine does not effect the other one.
 Also, a machine has to be installed in the environment where fresh air is always available.
 Keep enough space around the unit for inspection and maintenance access.
3.3.1 Installation

The machine has to be parked horizontally on a
level place.

In case the machine has to be parked on a slope,
place it across grade so that the machine does
not tend to roll downhill.
 Following grades on a slope for the machine are
recom- mended within 15
° degrees.
 In case of trailer type, be sure to put one set of
chocks “1” to the wheels.
3.3.2 Service valve
Installation
1
A100462
A100443
PC002
Discharge port : 20A(Rc3/4B)×2
[Taper male screw]