Pacific Research Solutions PET-820 User Manual
Page 22
Pacific Research
PET-820 User Manual
Page 21
4.5.2
CHANGE PROGRAM AUTHORIZATION CODE
Changing the PROGRAM AUTHORIZATION CODE consist of the command code value "12" followed by the new program
authorization code 1 to 6 digits. Any amount of digits may be used within the range of 1 to 6. Each digit with a value of 0
through 9. The default authorization code "987654" can be changed. Once this code is changed the default code will no
longer work.
COMMAND CODE:
12
PROGRAM SYNTAX:
12 [Data] #
READ BACK SYNTAX:
12 #
WHERE:
Data = 1 through 6 digits, each digit may be a value of 0 through 9
EXAMPLE:
12 123321 # = Changes the existing authorization code to "123321"
DEFAULT:
987654
4.5.3
CHANGE OPERATE KEY CODE
Changing the OPERATE KEY CODE consist of the command code value "13", followed by the new key code of 1 to 6 digits.
Any amount of digits may be used within the range of 1 to 6. Each digit with a value of 0 through 9. The default key code of
11 can be changed but once this code is changed, the default code will no longer work.
COMMAND CODE:
13
PROGRAM SYNTAX:
13 [Data] #
READ BACK SYNTAX:
13 #
WHERE:
Data = 1 through 6 digits, each digit may be a value of 0 through 9
EXAMPLE:
13 1441 # = Changes the existing operate key code to "1441"
DEFAULT:
11
4.5.4
CHANGE PASSWORD
Changing the PASSWORD consist of the command code value "14", followed by the new PASSWORD of 1 to 6 digits. Any
amount of digits may be used within the range of 1 to 6. Each digit with a value of 0 through 9. The default password "321"
can be changed but once this code is changed, the default code will no longer work.
COMMAND CODE:
14
PROGRAM SYNTAX:
14 [Data] #
READ BACK SYNTAX:
14 #
WHERE:
Data = 1 through 6 digits, each digit may be a value of 0 through 9
EXAMPLE:
14 5551 # = Changes the existing Password to "5551"
DEFAULT:
321
4.5.5
CHANGE UNIT ADDRESS
This is a 1 to 4 digit value that may be programmed in order to identify the location of the PET-820 that generated the alarm.
The speech command word 007 may be included into one of the message buffers to speak the unit address or identify the
source of an alarm.
COMMAND CODE:
15
PROGRAM SYNTAX:
15 [Data] #
READ BACK SYNTAX:
15 #
WHERE:
Data = 1 through 4 digits, each digit may be a value of 0 through 9
EXAMPLE:
15 1221 # = Change the existing Unit Address to "1221"
DEFAULT:
0000