Pacific Research Solutions PET-820 User Manual
Page 3
Pacific Research
PET-820 User Manual
Page 2
4.0
PROGRAMMING .................................................................................................... PAGE 19
4.1
Programming command format
4.2
Program Authorization Code
4.3
Valid data
4.3.1
Data types used
4.4
Examples of programming
4.5
Programming command codes
4.5.1
Set loop response time
4.5.2
Change program authorization code
4.5.3
Change operate key code
4.5.4
Change password
4.5.5
Change unit address
4.5.6
Arm delay
4.5.7
Communication delay before dialing
4.5.8
Alarm relay output cutoff time
4.5.9
Alarm delay
4.5.10
Password attempt errors
4.5.11
Communication dial attempts
4.5.12
Change telephone number
4.5.12.1
Configure for pager access
4.5.13
Select speech message buffer for update
4.5.14
Change message buffer data
4.5.15
Select sign message
4.5.16
Set ring counter
4.5.17
Select message delay
4.5.18
Alarm message repeat
4.5.19
Change loop configuration, Select active state
4.5.20
Change loop configuration, Select alarm delay
4.5.21
Change loop configuration, Select alarm relay output
4.5.22
Change loop configuration, Select phone access
4.5.23
Change loop configuration, Select response time
4.5.24
Change loop configuration, Select alarm message
4.5.25
Change loop configuration, Select monitor output
4.5.26
Eight telephone number log
4.5.27
Delete telephone number form log
4.5.28
Set day of week, RTC option
4.5.29
Alarm communication
4.5.30
Programming and control communication
4.5.31
Radio interface enable
4.5.32
Local ARM/DISARM control, enable
4.5.33
Loop 8, ARM/DISARM control, enable
4.5.34
Disable password requirement
4.5.35
Enable pulsing alarm relay output
4.5.36
Select DTMF/DIAL PULSE mode
4.5.37
Set time, RTC option
4.5.38
Set date, RTC option
4.5.39
Select serial port BAUD RATE
4.5.40
Reserved for future use
4.5.41
Reserved for future use
4.5.42
Reserved for future use
4.5.43
Reserved for future use
4.5.44
Serial port status enable
4.5.45
Initialization of speech data, RAM option required
4.5.52
System EEPROM initialization
4.5.53
Change direct byte in EEPROM
4.5.54
Demonstrate speech library
4.6
Analog input option, programming commands