Pacific Research Solutions PET-820 - Manual (Page 60)

Pacific Research PET-820 User Manual
Page 59
PROGRAMMING TABLE
Command
Code
Programming Command Description Command
Syntax
Factory
Setting
New
Setting
10 Set loop response time #1
40 Milliseconds to 10.2 Seconds, 001 = 40 mS 10 [DATA] # 001
40 mS
11 Set loop response time #2
40 Milliseconds to 10.2 Seconds, 025 = 1000 mS (1 Sec) 11 [DATA] # 025
1000 mS
12 Change PAC (Program Authorization Code)
1 to 6 Digits 12 [DATA] # 987654
13 Change Operate Key Code
1 to 6 Digits 13 [DATA] # 11
14 Change Password
1 to 6 Digits 14 [DATA] # 321
15 Change unit address
1 to 4 Digits 15 [DATA] # 0000
16 Set arm delay
000 to 255 Seconds 16 [DATA] # 015
Seconds
17 Set telephone dial delay after alarm
000 to 255 Seconds 17 [DATA] # 005
Seconds
18 Set alarm cutoff
000 to 255 Seconds 18 [DATA] # 030
Seconds
19 Set alarm delay
000 to 255 Seconds 19 [DATA] # 015
Seconds
20 Set password error counter
00 to 15 Errors, 00 = Disable counter 20 [DATA] # 02
Errors
21 Set communication dial attempts
00 to 15 Attempts, 00 = No communication attempts 21 [DATA] # 08
Attempts
22 Set telephone number 1
1 to 32 Digits 22 [DATA] # None
23 Set telephone number 2
1 to 32 Digits 23 [DATA] # None
24 Select speech message buffer to update
Buffer address 00 through 15 24 [DATA] # 00
Buffer 0
25 Change speech message data
Word Address 00 through 15
Word 000 through 255 25 <WORD ADDRESS> [WORD] # See Section
4.4.15
26 Select sign on message
Message buffer 00 through 15 26 [DATA] # 02
Buffer 2
27 Set ring counter for off hook
00 to 15 Rings
00=Disable counter or 15 rings with program switch on 27 [DATA] # 04
Rings
28 Select alarm message delay
Select 0 to 3, 0=None, 1=5 Sec., 2=15 Sec., 3=30 Sec. 28 [DATA] # 1
5 Seconds
29 Reserved for future use
Revised 10/13/92