Pacific Research Solutions PET-820 - Manual (Page 63)

Pacific Research PET-820 User Manual
Page 62
PROGRAMMING TABLE
Command
Code
Programming Command Description Command
Syntax
Factory
Setting
New
Setting
60 Reserved for future use
61 Reserved for future use
62 - 65 See OPERATE COMMAND TABLE
66 ADC OPTION: Reset analog high and low values
Select input 1 through 8 66 [INPUT] # None
67 See OPERATE COMMAND TABLE
68 ANALOG SCALING: Enable sign for analog scaled
values
Select input 1 through 8, Non Zero = Enable 68 [INPUT]
[DATA] #
0
Enable
69 ANALOG SCALING: Change speech identifier for analog
scaled values
Select input 1 through 8
Word = 000 through 255, String 1 to 4 words together. 69 [INPUT]
[WORD]
<WORD>
<WORD>
<WORD> #
245
"Volts"
70 ADC OPTION: Set upper analog alarm limit
Select input 1 through 8, Sign = Zero (neg)/Non Zero(pos)
Data = 0000 through 4096, ADC value 70 [INPUT]
[SIGN] [DATA] #
+4096
Limit
disabled
71 ADC OPTION: Set lower analog alarm limit
Select input 1 through 8, Sign = Zero (neg)/Non Zero(pos)
Data = 0000 through 4096, ADC value 71 [INPUT]
[SIGN] [DATA] #
-4096
Limit
disabled
72 ADC OPTION: Set input integrate rate
Data = 1 through 8 72 [INPUT]
[DATA] #
4
Readings
73 ADC OPTION: Enable input to trigger alarm
Select input 1-8, Data = Zero (disable)/Non Zero (enable) 73 [INPUT]
[DATA] #
0
Disable
74 ADC OPTION: Enable input to trigger alarm relay output
Select input 1-8, Data = Zero (disable)/Non Zero (enable) 74 [INPUT]
[DATA] #
0
Disable
75 ADC OPTION: Telephone number access
Select 0 to 7
0=None 1=Number 1
2=Number 2 3=Number 1 and 2,
4=8 Number log 5=Number 1 and log
6=Number 2 and log 7=Number 1, 2 and log 75 [INPUT]
[DATA] #
1
None
76 ADC OPTION: Select analog alarm message
Select input 1-8, Data = 00-15 (message buffer) 76 [INPUT]
[DATA] #
00
Message
77 ADC OPTION: Select alarm delay for analog alarm
Select input 1-8, Data = Zero (no delay)/Non Zero (delay) 77 [INPUT]
[DATA] #
0
No delay
78 ADC OPTION: Select single/differential ended input
Data = Zero (single)/Non Zero (diff.) 78 [DATA] # 0
Single end
79 ADC OPTION: Set analog high / low range
Select input 1-8, Data = Zero (low)/Non Zero (high) 79 [DATA] # 1
High range
80 Initialization of speech data, RAM/RTC Option 80 # None
81 System EEPROM Initialization, This command does not
require Password of Program Authorization Code 81 [SER. NO.] # None
82 Change direct byte in EEPROM
Address and data require 3 digit values 82 [ADDRESS]
[DATA] #
N/A
83 Demonstrate all words in speech library 83 # None
84 ADC OPTION: Initialization ADC 84 [SER. NO.] # None
Revised 12/14/94