SIGMA SD1 - Manual (Page 80)

79
SETTING OF THE CAMERA
3
Please set from [ Capture Settings] (P.28) → [RC Channel] and select the
same channel number as the remote controller.
4
Check that the subject is framed correctly. After you set the focus, we
recommend setting the lens switch to MF position.
5
Point the transmitting diode at the camera and press the transmit button.
6
After taking the picture, please cancel the Remote Control Mode following the
above procedure from number 3, and then choose OFF to cancel the remote
control function.
z
The Remote Control Mode cannot be used together with continuous shooting
mode. If the D-dial is set to the continuous shooting mode, the camera will expose
only one frame for each activation by the remote controller.
z The remote controller may not work properly if strong sunlight is shining directly
on the camera’s remote control sensor.
z The light entering the viewfinder can affect the exposure system of the camera. To
prevent this, use the finder cap while using the remote controller.
WARNING !!
•
When the Remote Control Mode is set to ON, Auto Power Off will not
function. If you are not using Remote Control please cancel the remote
control mode by choosing OFF.
•
It is not possible to use the remote controller with Bulb photograohy. If you
press the Transmit Button with the camera set to Bulb, the shutter will be
released with 1/180 second. (1/200 second will be displayed in the image
information.)