Sim2 MICO 50 - Manual (Page 51)

English
MiCO 50
13
setting up the screen
Position the projector perpendicular to the screen with all feet flat and level to achieve an optimal image.
note
The projector lens should be centered in the middle of the screen. If the horizontal line passing •
through the lens center is not perpendicular to the screen, the image will be distorted, making
viewing difficult.
For an optimal image, position the screen so that it is not in direct sunlight or room light. Light •
falling directly on the screen washes out the colors, making viewing difficult. Close the
curtains and dim the lights when setting up the screen in a sunny or bright room.
A polarizing screen cannot be used with this projector. •
standard setup (Front Projection)
Place the projector at the required distance from the screen according to n the desired picture size. (See page 14)
An Example of standard setup
90
Audience
90
side View
Top View
The distance from the screen to the projector may •
vary depending on the size of the screen.
The default setting can be used, when placing the •
projector in front of the screen. If the projected image
is reversed or inverted, readjust the setting to “Floor”
for “Orientation” in the “Image” menu.
Place the projector so that an imaginary horizontal •
line that passes through the center of the lens is
perpendicular to the screen.
note
2D Lens Shift Ability:
Range: UP 60%, Down 25%, •
Left 7.5%, Right 7.5%.
It is recommended that images be •
projected onto the dashed line octagonal
area for fine image quality.
There is a tolerance of ±2.5% in the •
formula above.
H H
V V