Step 1, Step 2, 2) connecting the tiss system – Space Ray PTS Series Single Stage User Manual
Page 28
Form 43343330
Aug 2012
-27-
12.2)
CONNECTING THE TISS SYSTEM
Description:
Description:
Description:
Description: The TISS
TISS
TISS
TISS (Tube Integrity Safety System)
(Tube Integrity Safety System)
(Tube Integrity Safety System)
(Tube Integrity Safety System) is designed to shut the main burner off in the event that a
burnout occurs in the first 10ft. section of firing tube. Note:
Note:
Note:
Note: When replacing the firing tube a new TISS
TISS
TISS
TISS wire
assembly PN 44176510 (spring
(spring
(spring
(spring and spring retainer clamp not included)
and spring retainer clamp not included)
and spring retainer clamp not included)
and spring retainer clamp not included) must also be installed.
Instructions
Instructions
Instructions
Instructions::::
1.
Make sure that the gap between the burner box and end of reflector is 3” and the reflector is securely
attached to the reflector support bracket. Make adjustments if necessary.
3 Gap (between
burner box and end
of reflector)
#10 x 1/2 Screws
must securely attach
reflector to the bracket
TISS Assembly.
Step 1
Failure to maintain 3 gap as shown will result in pre-mature TISS wire failure.
2.
Un-roll the TISS
TISS
TISS
TISS wire assembly from the spool. Be careful not to kink the wires.
Spool with TISS Wire
Assembly
Step 2