Tech Source Raptor Drivers for HP-UX - Manual (Page 15)

Chapter 3 - Software Installation
3-3
9. Follow the on-screen instructions to complete installation. If any
warnings or errors are reported, check the Logfile (default:
/var/adm/sw/swagent.log
), correct the errors, then
continue.
3.2.2 Installation on HP-UX 11.0
The following are step-by-step instructions for installing the Raptor
Drivers for HP-UX 11.0 software from a CD-ROM.
1. Install a supported Raptor card in the HP workstation/server, and
boot the system.
2. Log in as root on the target system, using /sbin/sh as your
shell.
3. Uninstall any previous version of Raptor software in accordance
with the instructions supplied with that software.
4. Insert the CD-ROM labeled “Raptor Drivers for HP-UX" into the
drive.
5. Run swinstall. Accept all the path defaults.
6. The swinstall program will automatically try to locate, mount,
and read any CD-ROM device present. If the program is
successful, it will display TSIRDHPUX_11 and TSIFTHPUX_11.
If this is not displayed, please proceed to the section titled,
“Mounting the CD-ROM Manually.” See Section 3.2.4.
7. Move the cursor down to the desired package and highlight it by
pressing <space>.
NOTE: You only need to install the packages for the graphics card
that you wish to use.