Tech Source Raptor Drivers for HP-UX - Manual (Page 19)

Chapter 3 - Software Installation
3-7
installation, or if for some other reason the device nodes are not
created, or if any Raptor cards are added to or removed from the
system after the software has been installed, then the Raptor drivers
must be reconfigured in order to create the proper device nodes
under /dev (i.e. /dev/raptor0, /dev/rap2kt1, etc.). To
reconfigure the Raptor drivers, issue the following two commands:
On HP-UX 10.20:
For Raptor 2000 cards:
# swconfig -u TSIRDHPUX_10
# swconfig TSIRDHPUX_10
For Raptor 2100T, Raptor 1100T and Raptor 2500T-DL cards:
# swconfig -u TSIFTHPUX_10
# swconfig TSIFTHPUX_10
On HP-UX 11.0:
For Raptor 2000 cards:
# swconfig -u TSIRDHPUX_11
# swconfig TSIRDHPUX_11
For Raptor 2100T, Raptor 1100T and Raptor 2500T-DL cards:
# swconfig -u TSIFTHPUX_11
# swconfig TSIFTHPUX_11
On HP-UX 11i:
For Raptor 2100T, Raptor 1100T and Raptor 2500T-DL cards:
# swconfig -u TSIFTHPUX_11i
# swconfig TSIFTHPUX_11i