Teletronics EZStation2 - Manual (Page 18)

WDS Settings
Wireless Distribution System uses wireless media to communicate with other APs, like
the Ethernet does. To do this, you must set these APs in the same channel and set MAC
address of other AP that you want to communicate with in the table and then enable the
WDS.
Item Description
Enable WDS Click the check box to enable wireless distribution
system.
MAC Address Fill in the MAC address of AP to register the
wireless distribution system access capability.
Comment Fill in the comment tag for the registered AP.
Apply Changes Click the Apply Changes button to register the AP
to new configuration setting.
Reset Click the Reset button to abort change and recover
the previous configuration setting.
Set Security Click button to configure wireless security like
WEP(64bits), WEP(128bits), WPA(TKIP),
WPA2(AES) or None
Show Statistics It shows the TX, RX packets, rate statistics
Delete Selected Click to delete the selected clients that will be
removed from the wireless distribution system.
Delete All Click to delete all the registered APs from the
wireless distribution system allowed list.
Reset Click the Reset button to abort change and recover
the previous configuration setting.