Teletronics EZStation2 - Manual (Page 21)

Refresh Click the Refresh button to re-scan site survey on
the screen.
Connect Click the Connect button to establish connection.
LAN Interface Setup
This page is used to configure the parameters for local area network that connects to the
LAN ports of your WLAN Broadband Router. Here you may change the setting for IP
address, subnet mask, DHCP, etc.
Item
Description
IP Address Fill in the IP address of LAN interfaces of this
WLAN Access Point.
Subnet Mask Fill in the subnet mask of LAN interfaces of this
WLAN Access Point.
Default Gateway Fill in the default gateway for LAN interfaces out
going data packets.
DHCP Click to select Disabled, Client or Server in
different operation mode of wireless Access Point.
DHCP Client Range Fill in the start IP address and end IP address to
allocate a range of IP addresses; client with DHCP
function set will be assigned an IP address from
the range.
Show Client Click to open the Active DHCP Client Table
window that shows the active clients with their