Teletronics IP-PBX Server - Manual (Page 14)

14
After press Modify can input detail setting for Trunk.
 Trunk Number: Assign the number of Trunk. This number is also the register name
for Trunk device.
Note:
•
The Trunk Number can also be a “Trunk ID”. In the Routing Table page, you
should define the destination of prefix route. When you define the prefix route,
you should set the Trunk ID (Trunk Number) in the Trunk page first; then you
could input the correct Trunk ID in the Destination field.
 Password: Assign the register password for device to register on EZLoop® IP-PBX
Enterprise SIP Server.
 Host: Setting the Host to Dynamic will require the trunk to register the EZLoop® IP-
PBX Enterprise SIP Server so that the EZLoop® IP-PBX Enterprise SIP Server knows
how to reach the trunk. You can also set the Host to an IP address or FQDN if you set
the Host to [Pre-define]. There will be a field called [Address] appear when you
choose Host to [Pre-define]. This limits only where you place calls to, as the user is
allowed to place calls from anywhere.
 DialPlan: Define the dialing plan for Trunk. It specifies the location of the instruction
used to control what the phone is allowed to do, and what to do with incoming calls for
this extension. In this field, you can Choose 6 dial level for Extension, including [from-
pstn], [ext-only], [ext+R1], [ext+R12], [ext+R123], [ext+allroutes]. You can define an
“Outgoing call” record, to a certain route level, as R1, R2…, etc. [from-pstn] is used for
Trunk only. [ext-only] means this subscriber can only call to Extension. [ext+R1]
means the subscriber with such DialPlan can call to Extension and Route Level with
R1. [ext+R12] means the subscriber with such DialPlan can call to Extension and
Route Level with R1 and R2. [ext+R123] means the subscriber with such DialPlan can
call to Extension and Route Level with R1, R2 and R3. [ext+allroutes] means the
subscriber with such DialPlan can call to Extension and Route Level with R1, R2, R3
and R4.
Note:
•
For more information about Route Level, please refer to the user manual: 3.1.5.1
Outgoing Call Rule.