Teletronics IP-PBX Server - Manual (Page 32)

32
•
If you set the Digits Length as a specific value, such as 10, the dialed
number digits length should full match to 10, or you can set the Digits Length
to 0 to ignore the digits length.
 Primary/Secondary/Third: User can set three priorities for each routing rule, if
EZLoop® IP-PBX Enterprise SIP Server fails to route to primary destination three
times, it will try to route to secondary or third destination.
 Destination: Here you can find some destination (Trunk) for choosing. You can define
the destination for the prefix route.
Note:
•
Before setting the Routing Table, you should set the Trunk info in the
Trunk page first. So that this field will contain the Trunk ID for choosing.
•
If the Trunk was setting to Dynamic in the Host field, but it doesn’t register on
EZLoop® IP-PBX Enterprise SIP Server, EZLoop® IP-PBX Enterprise SIP
Server will skip this “priority” and route call to next priority immediately without
trying. If the Trunk was setting to Address in the Host field, but the Address is not
reachable, EZLoop® IP-PBX Enterprise SIP Server will try three times then route
call to next priority.
 Add: To add assigned number. For example, you set 02 here and the called number
is 03123, the EZLoop® IP-PBX Enterprise SIP Server will add 02 then send 0203123
as the called number.
 Drop: To drop specified length of number. For example, you set 2 here and the
called number is 03123, the EZLoop® IP-PBX Enterprise SIP Server will drop 03 then
send 123 as outgoing number.
Note:
•
If you set both of the Drop and Add, EZLoop® IP-PBX Enterprise SIP Server will
Drop first then Add.
Example:
If user set prefix as
002 , digits length as 12, Primary destination as 888, Drop as 3 , and
Add as 0 .
When caller called 002 912345678, the prefix is 002 ; length is 12, so this call matches the
routing rule.
002 912345678_912345678(Drop 3 digits) _0912345678(Add 0 )
Finally, EZLoop® IP-PBX Enterprise SIP Server will send 0912345678 to Trunk ID 888.
 Route Password: Set password here so the EZLoop® IP-PBX Enterprise SIP Server
will request password before sending the call to Trunk.
 Guest Allow: Enable Guest Allow will allow user who is not your subscriber
(Extension) to use such routing record. User can reach the Auto attendant (The
default Auto Attendant of EZLoop® IP-PBX Enterprise SIP Server is **999) first then
send call to Destination (Trunk). If you enable Guest Allow. If you disable Guest Allow,
only the Extension can use this Routing record.
Note:
•
For more information, please refer to the CH5. Appendix-Application between
CPE device and EZLoop® IP-PBX Enterprise SIP Server.
 Route Level: You can define the Route Level for such route record. For example, you
define a route record with prefix 0 and the Route Level to R3. That means only the
subscriber with DialPlan [ext+R123] and [ext+allroutes] can use such record due to
only these two DialPlan contain the Route Level of R3.