Wavecom W-RCI (Remote Control) V8.7.0 - Manual (Page 50)

42

Parameter names and values XML SDK V8.7.0 Remote Control Interface
1800bps-uncoded
1200bps-uncoded
600bps-uncoded
300bps-uncoded
150bps-uncoded
75bps-uncoded
Values for X.25 code:
frame-format Values
basic
extended
super
free-run
When free-run is turned on a noisy signal can be displayed without horizontal synchronization.
Values
“on” or “off”.
letter-figure-mode
Sets the Letters and Figures cases in ITA-2 based modes.
Values
“normal”, “letters-only”, “figures-only” or “unshift-on-space”.
shift-register
“fec-a” shift register length.
Values
“72”, “128” or “off”.
display-mode
Display mode for the decoded data.
Values
“all-frames”, “no-error-frames” or “valid-frames-only”.
VDL-M2 specific values
“all-frames”, “valid-frames-only” or “indicate-erroneous-frames”.
display-format
Display format of the decoded data.
Values
“ascii”, “hex”, “ascii-hex”, “baudot”, "binary", “ascii-hex-baudot”, “raw”, “signaling-info”, “raw-bits” or
“all-blocks”.
modulation
Modulation type of the signal.
Values
modulation Values
am
bpsk
cw
d16psk
d8psk