Archgard 10-1800P - Manual (Page 12)

Chalet 1800 12
1. For easier assembly, tip the stove body on
its back (preferably onto a soft surface to
prevent scratching).
2. Slide the pedestal up against the bottom of
the stove. You will be aligning the 4 holes in
the corners of the pedestal with the corre-
sponding holes in the base of the stove.
3. Use a centering device, such as a center
punch and lift one corner of the pedestal and
push the centering device loosely through
the hole in the pedestal corner and into the
“Tee” nut in the base of the stove (If you
haven’t removed the bricks, be very careful
not to loosen them - two people would be
helpful for this job)
PEDESTAL ASSEMBLY
NOTE: The Chalet 1800 stove body comes
strapped to a pallet with the bricks, secondary air
tubes and baffle plates already installed.
Take care when laying the stove on its back to in-
stall the Pedestal or Leg and Bottom Shield / Skirt
Assembly. You may want to remove the bricks be-
fore laying the stove down.
The Pedestal Assembly and the Bottom Shield /
Skirt Assembly (skirt and ash drawer) come pack-
aged in separate boxes. The legs are packaged
separately as is the cast door.
PEDESTAL, BOTTOM SHIELD / SKIRT LEG - ASSEMBLY INSTRUCTIONS
4. Now swing the pedestal up so that the opposite
holes align and install and tighten the supplied
5/16” x ½” bolt and 2 washers per bolt with a ½”
wrench.
Remove the centering device and install the
remainder of the supplied 5/16” x ½” bolts and
washers and tighten them with a ½” wrench.
5. Lift the unit upright (two people would be help-
ful here also)
6. Slide in the ash drawer
7. Reinstall the bricks, if removed, and check the
positioning of the secondary air tubes and baf-
fle plates.
8. Correct positioning if necessary.
Unpack the stove and remove all the parts packed inside. Inspect all the parts and stove body for
shipping damage. Contact your dealer if any irregularities are noticed.