Archgard 10-1800P - Manual (Page 18)

Chalet 1800 18
1. Remove the fan assembly from the box and inspect
for any damage to the assembly. If damage is no-
ticed call your dealer, distributor or courier company
and have components replaced before installing kit.
2. Locate the 2 holes in the bottom back of the heat shield
of the stove (shown in the photo).
3. Locate the 2 holes it the back top of the fan (with the
louver facing back)
4. With the two #8 self tapping screws at the ready, slide
the outlet end of the fan up into the rear heat shield lining up the 2 holes with each other.
5. After aligning holes, secure the fan to the rear heat shield using the two screws provided.
CAUTION: The connection cord should not be in contact with any hot surfaces. Do not route cord un-
der or in front of unit.
BLOWER / FAN INSTALLATION
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three-pronged (grounding) plug for your protection against shock haz-
ard and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or re-
move the grounding prong from this plug.
FAN OPERATION
The Chalet 1800 is certified for operation with or
without the optional fan and may be installed at any
time by attachment at the back of the stove and
plugging in the 3-prong power cord.
Electrical Rating = 115V AC / 1.0 amps
Fan Output Rating = 150 c.f.m.
PART # FK-1800 FS
CAUTION
Label all wires prior to
disconnection when
servicing controls. Wiring
errors can cause improper
and dangerous operation
FAN WIRING DIAGRAM
The Chalet 1600 fan kit comes complete with a temperature
activated fan and solid stat speed control. The heat sensor is
factory set to close the circuit to the fan speed control at 110
0
F (43 0 C) and will turn off the fan when the temperature falls
below 80 0 F (27 0 C).
The speed can be adjusted up/down and off with the knob on
the side of the fan housing