Archgard 10-1800P - Manual (Page 13)

Chalet 1800 13
LEG ASSEMBLY
This applies to all painted and plated cast legs
1. Thread the 1/4” x 1” leveling bolts into the bottom of the
legs
2. Slip the 5/16” x 3/4” bolts through the very bottom of the
Bottom Shield / Skirt and install the supplied washer and
nut .
3. Slide each leg under the washer and tighten the nuts. Do
not over-tighten.
NOTE: Back leg sits flush with the back and side corner while
the front leg backs up against the front stop.
BOTTOM SHIELD / SKIRT ASSEMBLY
1. For easier assembly, tip the stove body on its back (preferably onto a soft surface to prevent scratch-
ing).
2. Slide the Bottom Shield / Skirt Assembly up against the bottom of the stove. You will be aligning the 4
holes in the corners of the Bottom Shield / Skirt Assembly with the corresponding holes in the base of
the stove.
3. Use a centering device, such as a center punch and lift one corner of the Bottom Shield / Skirt Assem-
bly and push the centering device loosely through the hole in the Bottom Shield / Skirt Assembly corner
and into the “Tee” nut in the base of the stove (If you haven’t removed the bricks, be very careful not to
loosen them - two people would be helpful for this job)
4. Now swing the Bottom Shield / Skirt Assembly up so that the opposite holes align and install and
tighten the supplied 5/16” x ½” bolt and 2 washers per bolt with a ½” wrench. Remove the centering
device and install the remainder of the supplied 5/16” x ½” bolts and washers and tighten them with a
½” wrench.
5. Lift the unit upright and place it into position on the floor (two people would be helpful here also). CAU-
TION! DO NOT TILT THE UNIT ON THE CAST IRON LEGS.
6. Slide in the ash drawer.
7. Reinstall the bricks, if removed, and check the positioning of the secondary air tubes and baffle plates.
Correct positioning if necessary.
8. Level the stove by adjusting the leveling bolts in the bottom of each leg.
5 / 16” x 3/4”
bolts &
washers
& nuts
Front leg
stop