Archgard 10-1800P - Manual (Page 7)

Chalet 1800 7
CAUTION
HOT WHILE IN OPERATION - DO NOT TOUCH.
KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY
CAUSE SKIN BURNS. READ NAMEPLATE AND INSTRUCTIONS.
LISTED SPACE HEATER, SOLID FUEL TYPE.
ALSO SUITABLE FOR MOBILE HOME INSTALLATION.
MODEL: CHALET 1800 FREE STANDING STOVE
TESTED TO: UL 1482-96 / ULC S627-00
SERIAL NUMBER / NUMÉRO DE SÉRIE:
DO NOT REMOVE THIS LABEL
BACKWALL
S
ID
E
W
A
LL
A
B
E
D
BACKWALL
S
ID
E
W
A
LL
G
H
J
I
G
ADJACENT WALL
S
ID
E
W
A
LL
F
C
PREVENT HOUSE FIRES:
INSTALL ONLY IN ACCORDANCE WITH THE MANUFACTURER’S INSTALLATION AND OPERATING INSTRUCTIONS. CONTACT LOCAL BUILD-
ING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION IN YOUR AREA. USE 6 in (152 mm) DIAMETER MINIMUM 24
MSG BLACK OR MSG BLUED STEEL CONNECTOR WITH LISTED UL103 HT (IN USA) OR ULC S629 (IN CANADA) FACTORY BUILT CHIMNEY
SUITIBLE FOR USE WITH SOLID FUELS OR MASONRY CHIMNEY. SEE LOCAL BUILDING CODE OR MANUFACTURER’S INSTRUCTIONS FOR
PRECAUTIONS REQUIRED FOR PASSING A CHIMNEY THROUGH A COMBUSTIBLE WALL OR CEILING, DO NOT PASS CHIMNEY CONNECTOR
THROUGH COMBUSTIBLE CEILING. DO NOT CONNECT THIS UNIT TO A CHIMNEY SERVING ANOTHER APPLIANCE.
MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS
MEASURE FROM HEATER FLUE CENTRE LINE
RESIDENTIAL INSTALLATION USING SINGLE WALL CONNECTOR
SIDEWALL A - 406 mm / 16” D - 711 mm / 28”
BACKWALL B - 406 mm / 16” E - 533 mm / 21”
CORNER C - 280 mm / 11” F - 585 mm / 23”
INSTALLATION USING LISTED DOUBLE WALL CONNECTOR - MOBILE HOME
SIDEWALL A - 406 mm / 16” D - 711 mm / 28”
BACKWALL B - 203 mm / 8” E - 311 mm / 12.25”
CORNER C - 280 mm / 11” F - 585 mm / 23”
INSTALLATION USING LISTED DOUBLE WALL CONNECTOR – RESIDENTIAL CLOSE CLEARANCE
SIDEWALL A - 406 mm / 16” D - 711 mm / 28”
BACKWALL B - 203 mm / 8” E - 311 mm / 12.25”
CORNER C - 280 mm / 11” F - 585 mm / 23”
INSTALLATION USING LISTED DOUBLE WALL CONNECTOR - ALCOVE
SIDEWALL G - 406 mm / 16” I - 711 mm / 28”
BACKWALL H - 203 mm / 8” J - 311 mm / 12.25”
MINIMUM ALCOVE CEILING HEIGHT : 2150 mm / 68”
MAXIMUM ALCOVE DEPTH : 915 mm / 36” (Minimum 38” clearance from stove top to ceiling)
8”
8” 8”
18”
FRONT
SI
D
E
SI
D
E
Canadian Installations
6” 6”
16”
FRONT
SI
D
E
SI
D
E
USA Installations
FLOOR PROTECTION
Any combustible flooring or floor covering beneath the appli-
ance and / or within the area extending horizontally beyond
the appliance on any side equipped with a door, and beyond
the appliance on the other sides and rear, shall be protected
by a continuous, durable, noncombustible pad that will provide
ember protection.
Refer to Canadian CSA B365 and USA NFPA 211 Installation
Codes for details.
UNITED STATES ENVIROMENTAL PROTECTION AGENCY
CERTIFIED TO COMPLY WITH JULY 1990 PARTICULATE EMISSION STANDARDS
For use with solid fuel only. Use of other fuels may damage the heater and create a hazardous condition. Do not obstruct combustion air opening. Operate
only with firebricks in place. Risk of smoke and flame spillage, Operate only with doors fully closed. Open front door to feed fire only. Do not use grate or
elevated fire, build wood fire directly on hearth. DO NOT OVERFIRE - IF HEATER OR CHIMNEY CONNECTOR GLOWS YOU ARE OVER-
FIRING. Inspect and clean chimney connector frequently, under certain conditions of use creosote build-up may occur rapidly. Keep furnishings and other
combustibles materials away from heater. Replace glass only with ceramic glass. Combustible floor may be protected by non-combustible material extend-
ing beneath the heater and to the front and sides as indicated or to the nearest permitted combustible material. Optional fan kit Part # FK-1800 electrical
rating 115 Volts 60 Hz 2 Amps. Danger risk of electrical shock, disconnect power before servicing unit. Components required for Mobile Home Installa-
tion: Outside Air Kit and double wall connector with listed chimney system.
Manufactured by: ARCHGARD INDUSTRIES LTD.
MISSION, BC ~ CANADA
Made in Canada
DE
C
NOV
OC
T
S
E
P
A
UG
JUL
JUN
M
A
Y
A
P
R
M
A
R
FE
B
JA
N
2015
DA
T
E
OF
M
A
N
F
A
C
T
UR
E
:
2014
2013
303-0142