Archgard 10-1800P - Manual (Page 14)

Chalet 1800 14
The door comes assembled with the glass and gasket.
1. Run the threaded end of the handle
through the hole in the cast door.
2. Insert the clevis pin into the roller and
washer.
3. Insert the end of the clevis pin assembly
into the hole in the end of the handle
4. Close the door and see how the door
closes. If it is too tight, turn the handle
clockwise to loosen it. If it is too loose,
turn the handle counter clockwise to
bring the door closer to the stove body.
5. To verify that the doors are well sealed,
insert a piece of paper between the
door and the stove body. You shouldn’t
be able to pull the paper out. Tighten it
to the point where the paper is starting
to tear when you are pulling it out.
6. Insert the cotter pin into the end of the
clevis pin to keep the assembly from
coming apart.
7. Attach spring handle by rotating the
spring counter clockwise onto the rod.
Ensure that the spring screws onto the
rod at least ½”.
9. Cover the holes with the two decorative
plug buttons
Clevis Pin
Cotter Pin
Roller
Washer
Cotter pin goes
through clevis pin
as shown here:
CAUTION: THIS UNIT CONTAINS SMALL PARTS DURING ASSEMBLY THAT SHOULD BE KEPT AWAY
FROM CHILDREN DUE TO CHOKING HAZARD WHICH COULD RESULT IN PERSONAL INJURY OR DEATH.