H3C Technologies H3C S12500-X Series Switches - Manual (Page 66)

57
• Server B can read and write only the data of Disk C.
Figure 21 Network diagram
Configuration considerations
• To meet these requirements, divide the SAN into two VSANs, VSAN 10 and VSAN 20. Each VSAN
contains a server and disk devices that can exchange data.
• Configure the two interfaces connecting Switch A to the servers to operate in F mode, and assign
the two interfaces as trunk ports to VSAN 10 and VSAN 20.
• Configure the three interfaces connecting Switch B to the disk devices to operate in F mode, and
assign the three interfaces as trunk ports to VSAN 10 or VSAN 20.
• Configure the interfaces connecting Switch A and Switch B to operate in E mode, and assign the
interfaces to VSANs 10 and 20 as trunk ports, so that the link between the two FCF switches can
send and receive the frames of the two VSANs at the same time.
Configuration procedure
1. Configure Switch A:
# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A.
(Skip this step if the switch is operating in advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Configure Switch A to operate in FCF mode, and create VSANs 10 and 20.
<SwitchA> system-view
[SwitchA] fcoe-mode fcf
[SwitchA] vsan 10
[SwitchA-vsan10] quit
[SwitchA] vsan 20