H3C Technologies H3C S12500-X Series Switches - Manual (Page 42)

35
<SwitchA> system-view
[SwitchA] l2vpn enable
# Enable Layer 2 forwarding for VXLANs.
[SwitchA] undo vxlan ip-forwarding
# Specify VXLAN 11111 as the reserved VXLAN for VXLAN IS-IS.
[SwitchA] reserved vxlan 11111
NOTE:
The reserved VXLAN must be the same across VTEPs.
# Create the VSI vpna and VXLAN 10000.
[SwitchA] vsi vpna
[SwitchA-vsi-vpna] vxlan 10000
[SwitchA-vsi-vpna-vxlan10000] quit
[SwitchA-vsi-vpna] quit
# Create the VSI vpnb and VXLAN 10001.
[SwitchA] vsi vpnb
[SwitchA-vsi-vpnb] vxlan 10001
[SwitchA-vsi-vpnb-vxlan10001] quit
[SwitchA-vsi-vpnb] quit
# Create the VSI vpnc and VXLAN 10002.
[SwitchA] vsi vpnc
[SwitchA-vsi-vpnc] vxlan 10002
[SwitchA-vsi-vpnc-vxlan10002] quit
[SwitchA-vsi-vpnc] quit
# Create the VSI vpnd and VXLAN 10003.
[SwitchA] vsi vpnd
[SwitchA-vsi-vpnd] vxlan 10003
[SwitchA-vsi-vpnd-vxlan10003] quit
[SwitchA-vsi-vpnd] quit
# Assign an IP address to Loopback 0.
[SwitchA] interface loopback0
[SwitchA-Loopback0] ip address 1.1.1.1 255.255.255.255
[SwitchA-Loopback0] quit
# Configure the NVE tunnel interface Tunnel 0. ENDP will set up VXLAN tunnels by using settings
on the NVE tunnel.
[SwitchA] interface tunnel 0 mode nve
[SwitchA-Tunnel0] source 1.1.1.1
[SwitchA-Tunnel0] network-id 1
# Enable ENDS on the NVE tunnel interface.
[SwitchA-Tunnel0] vxlan neighbor-discovery server enable
[SwitchA-Tunnel0] quit
# Create VLANs 2 to 5, and assign FortyGigE 1/0/1 to these VLANs.
[SwitchA] vlan 2 to 5
[SwitchA] interface fortygige 1/0/1
[SwitchA-FortyGigE1/0/1] port link-type trunk
[SwitchA-FortyGigE1/0/1] port trunk permit vlan 2 to 5