H3C Technologies H3C S12500-X Series Switches - Manual (Page 73)

66
Step Command Remarks
4. Return to system view. quit N/A
5. Enter VSI view. vsi vsi-name N/A
6. Specify the VSI interface as
the gateway interface for the
VSI.
gateway vsi-interface
vsi-interface-id By default, no gateway interface is
specified for a VSI.
Configuring a distributed VXLAN IP gateway
When you configure a distributed VXLAN IP gateway, you must perform the following tasks in addition
to the tasks in this section:
• Perform the required tasks in " Configuring basic VXLAN features " before you perform the tasks in
this section. Make sure Layer 3 forwarding is enabled for VXLANs.
• To provide Layer 3 access for any VXLANs to the external network, configure a default route. In the
route, set the next hop to the IP address of any VXLAN's VSI interface that is created on the border
gateway.
To configure a distributed VXLAN IP gateway:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a VSI
interface and enter
VSI interface view.
interface vsi vsi-interface-id
By default, no VSI interfaces exist on the
device.
3. Assign an IPv4
address to the VSI
interface.
ip address ip-address { mask |
mask-length }
By default, no IPv4 address is assigned to a
VSI interface.
This interface will be used as a gateway for
VXLANs.
4. Specify the VSI
interface as a
distributed gateway. distributed-gateway local
By default, a VSI interface is not a distributed
gateway.
5. Enable local proxy
ARP. local-proxy-arp enable
[ ip-range startIP to endIP ]
By default, local proxy ARP is disabled.
For more information about the command, see
Layer 3—IP Services Command Reference.
6. Return to system
view.
quit N/A
7. Enter VSI view. vsi vsi-name N/A
8. Specify the VSI
interface as the
gateway interface
for the VSI.
gateway vsi-interface
vsi-interface-id
By default, no gateway interface is specified
for a VSI.