H3C Technologies H3C WX5000 Series Access Controllers - Manual (Page 10)

1-4
Item Description
Max input voltage range
For AC power input: 90 VAC to 264 VAC, 47 Hz to 63 Hz
For DC power input: –36 VDC to –72 VDC
Power consumption 53.4 W to 67.7 W
z
You are not recommended to use an AC power module with a DC power module on the device.
z
No AC or DC power module is provided with the access controller. You need to prepare them
yourself.
Components
LEDs
The WX5002V2 provides LEDs on the front panel, as shown in Figure 1-4 .
Figure 1-4 LEDs of the WX5002V2
(1) 1000 Mbps LED of gigabit Ethernet interface (1000M)
(2) System status LED (SYS)
(3) Status LED of PSU 1 (PWR1)
(4) 10/100 Mbps LED of gigabit Ethernet interface (10/100M)
(5) LED of the expansion card (MOD)
(6) Status LED of PSU 2 (PWR2)
Table 1-6 Description of LEDs
LEDs Silkscreen Status Description
Solid green
PSU 1 supplies power to the system
normally.
Solid yellow PSU 1 is faulty.
LED of PSU 1
(green/yellow)
PWR1
Off No PSU is installed in the slot.
Solid green
PSU 2 supplies power to the system
normally.
Solid yellow PSU 2 is faulty.
LED of PSU 2
(green/yellow)
PWR2
Off No PSU is installed in the slot.