Grass Valley DD35 Family v.3.1.5 - Manual (Page 306)

3. Menu Operation DD35 Production Switcher
3 – 154 Operating Instructions – Rev. 16 / 10.2001
3.15.3.2 Dialog Buttons
(not yet implemented)
With machine couple you will be in a position to gang machines (see below) with
a constant timecode offset. In contrary to gang–mode one machine is defined as
master and the rest of the machines are ”coupled”.
(not yet implemented)
All machines belonging to one gang (up to 4 gangs are possible) will be controlled
in parallel, that means, a tape motion command send to one of the machines is du-
plicated for all machines in the gang.
got to start
play reverse
stop
play
go to end
record
In the actual software version recording per channel will always start from
00:00:00:00 and will record the total time.
If you want to use a channel as a stillstore, for this sw–version it is recommended
to pre–edit the stills to one sequence and record this sequence in total.
With ”Modify/Settings” you can set in–points and out–points for the selected ma-
chine (light blue border).
With ”Modify/Goto” you can goto the according in–points and out–points or to an
absolute timecode.
Macros with ”Modify/Goto/Timecode” can be used to recall stills.
Machine Couple
Gang
Motion control
buttons